Replace with multipoint lock 499130004 and strike kit 37400109 or 499130054.

Trilennium 3000 series Multi-Point Lock with looking Latch Bolts - Multi-point lock with Strike Plates 

IMPORTANT - all locks are set up for INSWING doors. If you have an OUTSWING the Panic function needs to be checked before installation.  
Strike kit and accessories are included 

Lock Measurements: 
Backset: 2-3/8 (60 mm) 
Faceplate Width: 1 inch (25.4 mm) 
Faceplate Length: 65-1/2 inch (1410 mm) Radius ends 
Faceplate Color: 3 Finishes; Polished Brass, Victorian Bronze, Stainless Steel 
Deadbolt Throw: 15/16 inch 
Top Latching Bolt: 33 inch (measured from center bolt) 
Bottom Latching Bolt: 24-1/4 inch (measured from center bolt) 
Spindle Diameter: 1/4 inch ( 7 mm) 
Cylinder Type: American with Flat tail piece, Not included 
Country of Origin: Made in USA 
Priced and sold each, Lock assembly only, no additional hardware 

Handed: Right-hand inswing door (reversible / see video below)
Handing As viewed from outside, hinge determines handing - If hinge is on left, it is left hand door. 

Operation: 
Handle moves down only 
To lock - Use key or thumb turn - Extends Latch to Deadbolt function 
To unlock - Use Key Outside or Thumb Turn / Lever Inside 
Panic Release: Yes, Pressing down on inside handle will unlock door 

HARDWARE NOTE: 
Standard Trilennium Cross Bore: 2-1/8 inch (use Pinnacle, Eclipse & Grip Hardware) 
Optional Crossbore: 1-11/16 (use Europa, Horizon & Emtek hardware) 
The Horizon and Europa plates are only 1-7/8 inches wide and will not cover the 2-1/8 inch crossbore used on Pella and other doors with larger holes